7075 T6 Bar & Extrusions Grade - Aluminium

Range Enquiry

To enquire about our range or your specific requirements, please contact your local service centre.

Temper Types

Properties

Chemical Composition

Chemical Element	% Present
Silicon (Si)	0.00 - 0.40
Iron (Fe)	0.00 - 0.50
Copper (Cu)	1.20 - 2.00
Manganese (Mn)	0.00 - 0.30
Chromium (Cr)	0.18 - 0.28
Magnesium (Mg)	2.10 - 2.90
Zinc (Zn)	5.10 - 6.10
Titanium (Ti)	0.00 - 0.20
Other (Each)	0.00 - 0.05
Others (Total)	0.00 - 0.15
Aluminium (Al)	Balance

Mechanical Property	Value
Proof Stress	480 Min MPa
Tensile Strength	540 Min MPa
Elongation A50 mm	7 Min %

General Physical Properties

Physical Property	Value
Density	2.80 g/cm³
Melting Point	635 °C
Thermal Expansion	23.5 x 10^-6/K
Modulus of Elasticity	72 GPa
Thermal Conductivity	130 W/m.K
Electrical Resistivity	40 % IACS

Applications

Aircraft structures
Gears and shafts
Automotive
Bicycle components
Rock climbing equipment

Characteristics

Excellent mechanical properties
Good ductility
High strength and toughness
Good resistance to fatigue
Superior stress corrosion resistance

Find your local Service Centre

Experienced multi-product specialists
In-house state of the art processing facilities
Large fleet of bespoke delivery vehicles

Disclaimer

This Data is indicative only and as such is not to be relied upon in place of the full specification. In particular, mechanical property requirements vary widely with temper, product and product dimensions. All information is based on our present knowledge and is given in good faith. No liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon. Please note that the 'Datasheet Update' date shown above is no guarantee of accuracy or whether the datasheet is up to date.

The information provided in this datasheet has been drawn from various recognised sources, including EN Standards, recognised industry references (printed S online) and manufacturers' data. No guarantee is given that the information is from the latest issue of those sources or about the accuracy of those sources. Material supplied by the Company may vary significantly from this data but will conform to all relevant and applicable standards. As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose, whether expressed or implied. Advice given by the Company to any third party is given for that party's assistance only and without liability on the part of the Company. All transactions are subject to the Company's current Conditions of Sale. The extent of the Company's liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.

Aluminium, Commercial Alloy7075 T6 Bar & Extrusions

A high strength aerospace aluminium alloy.

Range Enquiry

Temper Types

Properties

Alloy 7075

Drawn Bar Up to 25mm

7075T6

Applications

Characteristics

Find your local Service Centre