2011 T3 Rod and Bar
Aluminium alloy 2011 is a high mechanical strength alloy that machines exceptionally well. Often called a Free Machining Alloy or ‘FMA’ it is well suited to use in automatic lathes.
Machining at high speeds produces fine chips that are easily removed. The excellent machining characteristics allow the production of complex and detailed parts. In some circumstances 2011 can replace free machining brass without the need for alterations to tooling.
It has poor corrosion resistance, which means parts made from 2011 tend to be anodised to provide additional surface protection.
When higher levels of corrosion resistance are required, 6262 T9 may be a suitable replacement.
Applications - 2011 is typically used in applications that require parts manufactured by repetition machining. These applications may include:
Appliance parts & trim
Fasteners and fittings
BS EN 573-3:2009
|Chemical Element||% Present|
|Silicon (Si)||0.0 - 0.40|
|Iron (Fe)||0.0 - 0.70|
|Copper (Cu)||5.00 - 6.00|
|Lead (Pb)||0.20 - 0.40|
|Bismuth (Bi)||0.20 - 0.60|
|Zinc (Zn)||0.0 - 0.30|
|Others (Total)||0.0 - 0.15|
|Other (Each)||0.0 - 0.05|
Aluminium alloy 2011 also corresponds to the following standard designations and specifications but may not be a direct equivalent :
Generic Physical Properties
|Modulus of Elasticity||70 GPa|
|Electrical Resistivity||0.038 x10^-6 Ω .m|
|Thermal Conductivity||151 W/m.K|
|Thermal Expansion||22.9 x10^-6 /K|
|Melting Point||535 °C|
BS EN 755-2:2008
Extruded and Drawn Bar - Up to 200mm Dia. or 60mm A/F
|Proof Stress||270 Min MPa|
|Tensile Strength||320 Min MPa|
|Hardness Brinell||90 Min HB|
|Elongation A||10 Min %|
Alloy 2011 has extremely poor weldability and thus welding is not recommended. However, as it is used for machined parts there is rarely a need to weld this alloy.
Workability - Cold Fair
Weldability – Gas Poor
Weldability – Arc Poor
Weldability – Resistance Poor
This Data is indicative only and as such is not to be relied upon in place of the full specification. In particular, mechanical property requirements vary widely with temper, product and product dimensions. All information is based on our present knowledge and is given in good faith. No liability will be accepted by the Company in respect of any action taken by any third party in reliance thereon.
Please note that the 'Datasheet Update' date shown above is no guarantee of accuracy or whether the datasheet is up to date.
The information provided in this datasheet has been drawn from various recognised sources, including EN Standards, recognised industry references (printed & online) and manufacturers’ data. No guarantee is given that the information is from the latest issue of those sources or about the accuracy of those sources.
Material supplied by the Company may vary significantly from this data, but will conform to all relevant and applicable standards.
As the products detailed may be used for a wide variety of purposes and as the Company has no control over their use; the Company specifically excludes all conditions or warranties expressed or implied by statute or otherwise as to dimensions, properties and/or fitness for any particular purpose, whether expressed or implied.
Advice given by the Company to any third party is given for that party’s assistance only and without liability on the part of the Company. All transactions are subject to the Company’s current Conditions of Sale. The extent of the Company’s liabilities to any customer is clearly set out in those Conditions; a copy of which is available on request.